Ultradyne USA

Ultradyne USA ATHENA Linear Compensator - 762NATO/308 Winchester, Fits AR-10s with 5/8X24 Threads, Black, 4.6 oz., 416 Stainless Steel, Includes Shrouded Timing Nut

MSRP: $69.95
$62.00
( saved $7.95 )
No reviews yet Write a Review
Adding to cart… The item has been added
SKU:
UD10690
UPC:
851019008293
  • $7.95 Flat Rate Shipping

  • Easy Returns

  • Safe Payments

  • The Best Products

ATHENA is Ultradyne’s linear compensator. Muzzle rise has been optimized, with gas vented at an angle then forward. This sends a lower percent of sound and gasses back towards the shooter, optimizing sonic performance over recoil. Athena gives a cleaner appearance for a sleek look compared to traditional brakes and is the most cost-effective way to upgrade a rifle to the Dynamount Sighting System. Like all Ultradyne muzzle devices, a timing nut is included for easy installation ( Crush washer for the .350 caliber). Available in the following; .223  / 5.56, .308 / 7.62 and 350 Legend.

  • Vents Gases forward
  • Timing nut included for easy installation and indexing
  • Indexing slots compatible with the Dynamount Front Sight allow for a standard upright alignment or a 45 degree offset
  • 100% CNC-machined quality
  • 100% Made in the USA

LINEAR COMPENSATION
Forward-directed signature for greater shooter comfort.

100% CNC MACHINED IN THE USA
416 Stainless Steel with ultra-rugged salt bath nitride finish.

DYNAMOUNT READY
Barrel mounted sight option eliminates sight deflection associated with handguard mounting.

 

Athena .308 | 7.62 Technical Specs

  • CALIBER
    • Rated for the standard cartridges in the following calibers: 308 Win, 7.62×51 NATO, 300 AAC Black Out, 300 Savage, 303 Savage, 30-30 Win
  • BARREL THREAD 5/8-24 UNEF-2B
  • BARREL THREAD LENGTH MINIMUM    .600″
  • MATERIAL
    • 416 Stainless Steel
    • Salt Bath Nitride Finish
  • MOUNTING Shrouded Timing Nut
  • MASS
    • Brake Only 130 grams | 4.6 ounces
    • Total 158 grams | 5.56 ounces
  • DIMENSIONS
    • Length 43mm | 1.70 inches
    • OD 27.9 mm | 1.10 inches
  • WRENCH FLATS 1 inch

 

 

  • Installation Instructions For Crush Washer:

    1. Inspect and clean threads on barrel and muzzle device.
    2. Place the crush washer cone forward over the muzzle threads, then thread the muzzle device up against the crush washer.
    3. Hand tighten the muzzle device and note that crush must be flush with barrel shoulder and fully depress the detent.
    4. Using a wrench, turn the muzzle device 1/4 turn, then continue to tighten to index properly. If the muzzle device is tightened past desired position, start over with a new crush washer.
    5. Check concentricity with a bore alignment rod.
    6. Test fire at 25 yards into a paper target backed up by a minimum 15′ x 15′ safety berm capable of safely stopping projectiles. Verify the ability to shoot groups and inspect for baffle strikes for all loads that will be used.