These grips are made of soft rubber with a cobblestone (stippled) surface for good grip control. One-piece monogrip design with a screw that attaches to the base of the grip frame. Finger grips, palm swells and relieved for speedloaders. Conversion grips convert a round butt frame to a square butt feel or vice versa.
Notes:
- This grip fits the listed revolvers with a 1/2" thick frame, does NOT the 7/16" frame revolvers
- Will fit Super Single Six
- Cowboy panels Will fit Old Army Blackpowder (usually requires fitting)
- Will fit THE NEW MODEL Blackhawk XR-3 Frame
- Will NOT fit OLD XR-3 frame* (old flat top, 3 screw model)
- Will fit standard new model Super Blackhawk with round trigger guard
- Will NOT fit "Hunter" model Super Blackhawk with round trigger guard, this revolver is factory equipped with dovetail cutouts for mounting scope
- Will fit Wrangler model
- Stirrup pin goes through large opening in frame
- Monogrips have two pins are included, Most newer guns use the small steel pin. Older frames use the larger aluminum pin.
